Blade® 2M (Mil-spec)

BB 2M

$41.95

BB 2M

Description

Blade® 2M (Mil-Spec)

Made from high-strength glass-reinforced polymer, the adjustable Shockwave Blade 2M pistol stabilizer is manufactured to exacting tolerances and fits all pistols equipped with a Mil-spec buffer tube. Just slip it on and lock in place.  Adjusts with a simple finger lever.

  • Fits all pistols equipped with a Mil-spec buffer tube: AR-15 pattern, MPX, Glock, CZ Scorpion Evo 3, HK9X pattern, etc.
  • Available in Black, FDE, ODG, Gray
  • Quick and easy to install.
  • Provides additional support during firing.
  • Weighs a scant 4.0 ounces.
  • ATF approved for pistol use 
  • Veteran designed
  • Made in U.S.A.

Mil-spec tubes available here.

 

Additional information

Weight 4.1 oz
*

Black, FDE, OD Green, Gray

You may also like…

34 replies on “Blade® 2M (Mil-spec)”

Just to confirm before I load up my cart and pull my proverbial trigger as it were;

The Blade 2M will be able to properly lock in place on a Mil-spec buffer tube – yes/no?

Thank you for catching that. It is only 4.0 oz. the 4.1 is for the shipping of the package.

Thanks,

Team Shockwave

Hi! Is this a direct replacement for the standard Blade® Pistol Stabilizer? Will the same buffer tube accommodate both Blade® Pistol Stabilizer and Blade 2M? I have the standard unadjustable Blade Stabilizer on my AR-15 pistol, thx!

I’d like to install the 2M on some of my AR pistols. However, I’m reading complaints that many fit very loosely (rattle fit) on mil-spec buffer tubes. Is the polymer used a type that I can heat with a hot air gun and reshape slightly to tighten the slip-fit if I receive one with a loose, rattle fit? Love your product concept and thanks for your time!

Hi Micke,

This has been addressed with the ones we are shipping out now. You can exchange if it is causing issue. If you have an older one you are welcome to do what you want to it.

Thanks,
Team Shockwave

My Blade G2 has an issue with it’s retainer and now slips(collapses) under minor impact or recoil. Are they covered under warranty?

When fully collapsed, is the end of the blade flush with the end of the buffer tube or does it extend past the tube? Thanks

Hi, I removed the pin, spring, and lever to paint two of my blade 2’s and lost them in the process. Any way I can order replacements?

Hi Mike,

I think Cynthia already took care of this for you. Let us know if you need anything else.

Thanks,

Team Shockwave

I believe that has a milspec buffer tube but you will want to verify. If yes, this stabilizer will work.

Thanks,
Team Shockwave

I believe that has a milspec buffer tube but you will want to verify. If yes, this stabilizer will work.

Thanks,
Team Shockwave

Leave a Reply

Your email address will not be published. Required fields are marked *